| View previous topic :: View next topic |
| Author |
Message |
miles.
Joined: 19 Mar 2006
Posts: 6
Location: kalamazoo, michigan.
|
 Posted: Sun Mar 19, 2006 5:57 pm Post subject: Meissner Model 9-1065 |
 |
|
hello. i just bought this cutter(and it should be coming in the mail in the next few day) and im curious if anyone has any experiences with this cutter before?
the seller says that it cuts but "cuts with noise". any things to consider before it comes on how to fix this problem?
it came with:
-3 blank disks
-9 cutting needles (steel)
-2 reproducing needles (1 sapphire, 1 osmium)
 |
|
| Back to top |
|
 |
miles.
Joined: 19 Mar 2006
Posts: 6
Location: kalamazoo, michigan.
|
| Posted: Tue Jul 11, 2006 2:28 pm Post subject: |
|
|
| this still cuts with a good amount of high end surface noise, im not really sure where to start to fix this problem. does anyone have any ideawhat might be the cause of this problem? |
|
| Back to top |
|
|
cuttercollector
Joined: 11 Jun 2006
Posts: 258
Location: San Jose, CA
|
| Posted: Tue Jul 11, 2006 3:56 pm Post subject: surface noise |
|
|
| If there is still a lot of mechanical surface noise in a quiet unmodulated groove, I think I would try a variety of new lacquers, and fiddle as much as I could with a combination of adjusting the depth the cutting stylus is inserted into the head, which will change the cutting angle slightly, and also the depth adjustment, which will interact. But a good sharp stylus with well polished burnishing facets cutting into nice fresh lacquer is probably the only way to obtain a quiet cut, without stylus heat. |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
